Report a problem
Judy's Book takes violations of our Terms of Use very seriously. We encourage
you to read through our
Terms of Use
before filling report with us.
After careful review, we may remove content or replace a content warning page before
viewing content deemed offensive, harmful, or dangerous.
Additionally, we are aware that there may be content on Judy's Book that is personal
in nature or feels invasive. Please note that Judy's Book is a provider of content
creation tools, not a mediator of content. We allow our users express their opinions,
but we don't make any claims about the content of these pages. We strongly believe
in freedom of expression, even if a review contains unappealing or distasteful
content or present negative viewpoints. We realize that this may be frustrating,
and we regret any inconvenience this may cause you. In cases where contact information
for the author is listed on the page, we recommend that you work directly with this
person to have the content in question removed or changed.
Here are some examples of content we will not remove unless provided with a court
order:
Personal attacks or alleged defamation
Political or social commentary
Distasteful imagery or language
If we've read the Terms of Use and believe that this review below violates our Terms
of Use, please complete the following short form.
|
Businiess name:
SAPPS Welding & Radiator, Inc.
|
|
Review by:
Guest
|
|
Review content:
I had a radiator replaced by Sapps. It started leaking after 6 months. When I took it back, they said my car was the problem and that I must have a blown head gasket. Two other repair shops said there was nothing wrong with my engine and that the radiator looked used instead of new as shown on the invoice from Sapps. After pressing the issue, they finally agreed to fix it. The 2nd radiator looked new like it was supposed to be, but after a few days I had to take it to another shop because Sapps didn't tighten my transmission lines and most of my fluid leaked out. They also installed something incorrectly that caused my throttle to stick. The 2nd shop had to partially remove the radiator to fix the problem. I will never use Sapps again.
|
Reasons for reporting (512 characters left):
|
|
Reasons are required.
|
|
or
Cancel
|