Report a problem
Judy's Book takes violations of our Terms of Use very seriously. We encourage
you to read through our
Terms of Use
before filling report with us.
After careful review, we may remove content or replace a content warning page before
viewing content deemed offensive, harmful, or dangerous.
Additionally, we are aware that there may be content on Judy's Book that is personal
in nature or feels invasive. Please note that Judy's Book is a provider of content
creation tools, not a mediator of content. We allow our users express their opinions,
but we don't make any claims about the content of these pages. We strongly believe
in freedom of expression, even if a review contains unappealing or distasteful
content or present negative viewpoints. We realize that this may be frustrating,
and we regret any inconvenience this may cause you. In cases where contact information
for the author is listed on the page, we recommend that you work directly with this
person to have the content in question removed or changed.
Here are some examples of content we will not remove unless provided with a court
order:
Personal attacks or alleged defamation
Political or social commentary
Distasteful imagery or language
If we've read the Terms of Use and believe that this review below violates our Terms
of Use, please complete the following short form.
|
Businiess name:
Ward Forging Co Inc
|
|
Review by:
citysearch c.
|
|
Review content:
I would not recommend Ward forging! I needed a piece of stainless steel tubing rolled for a sculpture I was commissioned to build. They were the closest place I could find that can roll 2"" d tubing and were recommended by many people. They mangled it really badly and then told me it was my fault for not telling them that the wall gauge was too thin. They had the metal in their hands when they put it in the roller! Not to mention I don't roll my own metal because that is not what my profession is. I took it to them because that is what they do for a living! I am now out $350 in metal that is so mangled I can't use it and had to buy another thicker walled piece so that they could roll it without destroying it. When I called and talked to the owner to question why I was being charged for the work considering how much money they had already cost me in materials he told me that they were being nice by only charging me to roll one piece instead of two! He then asked what the piece was being used for and when I told him it was for a sculpture commissioned by the federal government, he said ""Oh, that explains why it has to look good. A lot of times when we roll things for sculptors, it doesn't matter what it looks like because it is for an armature or something"". I still don't understand why it matters what I am using the metal for. I think the same care should be taken no matter what will be done with it and if you screw something up, you should make it right! I will drive as far as I have to the next time I need something rolled to avoid going to Ward Forging!
|
Reasons for reporting (512 characters left):
|
|
Reasons are required.
|
|
or
Cancel
|