Report a problem
Judy's Book takes violations of our Terms of Use very seriously. We encourage
you to read through our
Terms of Use
before filling report with us.
After careful review, we may remove content or replace a content warning page before
viewing content deemed offensive, harmful, or dangerous.
Additionally, we are aware that there may be content on Judy's Book that is personal
in nature or feels invasive. Please note that Judy's Book is a provider of content
creation tools, not a mediator of content. We allow our users express their opinions,
but we don't make any claims about the content of these pages. We strongly believe
in freedom of expression, even if a review contains unappealing or distasteful
content or present negative viewpoints. We realize that this may be frustrating,
and we regret any inconvenience this may cause you. In cases where contact information
for the author is listed on the page, we recommend that you work directly with this
person to have the content in question removed or changed.
Here are some examples of content we will not remove unless provided with a court
order:
Personal attacks or alleged defamation
Political or social commentary
Distasteful imagery or language
If we've read the Terms of Use and believe that this review below violates our Terms
of Use, please complete the following short form.
|
Businiess name:
ShiftsGood Transmission
|
|
Review by:
citysearch c.
|
|
Review content:
Well to start with when I picked the car up the SRS light was on and despite their efforts this could not not be resolved. While on the way home the ABS light came on. I arrived at home and pulled the right side wheel off and found that the ABS sensor was not connected, but was hanging loose. I bolted the sensor in place. I decided to check the left side and that sensor was OK. While putting the left side wheel on I noticed that the hub was loose, the left spindle nut was not tight! This was a nightmare waiting to happen. I properly tightened and locked the nut. Certain things must be done correctly and properly tightening the spindle nuts ranks way up there. I will never use this shop again.
|
Reasons for reporting (512 characters left):
|
|
Reasons are required.
|
|
or
Cancel
|