Report a problem
Judy's Book takes violations of our Terms of Use very seriously. We encourage
you to read through our
Terms of Use
before filling report with us.
After careful review, we may remove content or replace a content warning page before
viewing content deemed offensive, harmful, or dangerous.
Additionally, we are aware that there may be content on Judy's Book that is personal
in nature or feels invasive. Please note that Judy's Book is a provider of content
creation tools, not a mediator of content. We allow our users express their opinions,
but we don't make any claims about the content of these pages. We strongly believe
in freedom of expression, even if a review contains unappealing or distasteful
content or present negative viewpoints. We realize that this may be frustrating,
and we regret any inconvenience this may cause you. In cases where contact information
for the author is listed on the page, we recommend that you work directly with this
person to have the content in question removed or changed.
Here are some examples of content we will not remove unless provided with a court
order:
Personal attacks or alleged defamation
Political or social commentary
Distasteful imagery or language
If we've read the Terms of Use and believe that this review below violates our Terms
of Use, please complete the following short form.
|
Businiess name:
Seattle Coffee Gear
|
|
Review by:
Guest
|
|
Review content:
I purchased a brand new PID from seattlecoffeegear for around $260.00. This little device is supposed to make your coffee espresso way easier. I cut a hole for it in my Brand NEW Machine Rancilio Silvia to install it. It took me 4 hours to install, but every step I took I had to double check because my machine is so expensive. I don’t want to make any type of mistakes to cause damage. After all the wiring and installation was done I turned it on for the first time. This PID system supposedly holds the brewing temperature more accurately, but for some reason temperature goes way above the safety limit. So I was scared it would damage my machine and I turned it off. Next I call seattlecoffeegear and spoke to Nakita from technical support. He then guided me through what I was supposed to do. First he thought it had been programmed wrong from the factory. Furthermore after all the many steps I took, he found that there was no problem. He then told me to watch a video on YouTube to show me how to program it, then to call him back after I was done watching the video. I didn’t receive his video, but I found one where Gail explained how to program the PID (There has been plenty of times I had watched videos with Gail, and that enticed me to order this precise system from them. That was a BIG MISTAKE and was very disappointed, so I called Nakita back, told him I never received an email from him with the link for that video. I then told him I found it, and watched it. He asked me only a couple of questions what the settings said on the display to make sure everything was correct. He didn’t come up with any problems. Nakita came up with an idea to record a video again after many times from beginning to make sure that he could clearly see the rising temperature, and make sure all buttons are set correctly. I made a video but unfortunately it was too long and he wanted to have the entire video footage. I told him the video was 780mb (huge file) he then told me to send it to him ...
|
Reasons for reporting (512 characters left):
|
|
Reasons are required.
|
|
or
Cancel
|