Report a problem
Judy's Book takes violations of our Terms of Use very seriously. We encourage you to read through our Terms of Use before filling report with us.
After careful review, we may remove content or replace a content warning page before viewing content deemed offensive, harmful, or dangerous.
Additionally, we are aware that there may be content on Judy's Book that is personal in nature or feels invasive. Please note that Judy's Book is a provider of content creation tools, not a mediator of content. We allow our users express their opinions, but we don't make any claims about the content of these pages. We strongly believe in freedom of expression, even if a review contains unappealing or distasteful content or present negative viewpoints. We realize that this may be frustrating, and we regret any inconvenience this may cause you. In cases where contact information for the author is listed on the page, we recommend that you work directly with this person to have the content in question removed or changed.
Here are some examples of content we will not remove unless provided with a court order:
Personal attacks or alleged defamation
Political or social commentary
Distasteful imagery or language
If we've read the Terms of Use and believe that this review below violates our Terms of Use, please complete the following short form.

Businiess name:  John's Specialty Services
Review by:  citysearch c.
Review content: 
Didn?t get what I wanted and paid for! Paper work reflected different parts then I wanted, Very bad quality, engine had very low miles under 2k, low oil pressure 17 lbs at idle, builder said that was good enough, safety equipment shuts engine off less than 20 lbs, u would think they would know that,knocking at the main bearing and rocker arm noise, pulled it and returned under warranty it was disassembled in front of me, we seen damage of rear main bearing, crank man said something went thru it and the builder was pulling chunks of gasket from oil pump screen, which they cleaned along with other major parts, picked it up few days later, paper work stated there was nothing wrong with it, checked all clearances, heads so forth, how can that be, seen the damaged bearing my self along with them, it was like polished chrome, not enough clearance using plastic gauge would have shown that. reinstall in the engine, what do I hear! valve train noise again, was told again that?s normal, Notta, after the warranty was up and I was tired of the noise so I looked to see what could be making the noise, boy was I shocked, I found that the rocker arms were completely worn out and lifter preload was all over.105. the valve springs were not installed correct, best at 90lbs S/B 110 thru 120 for the camshaft to work thru the rpm range,also found that they used defective retainers, which the manufacture replaced at n/c to them, now you would think they would change them for me because they made the mistake, no they said, here yah go, and you change them.i mean they were so defective how could you miss that after two inspections, would be like missing a thumb from the hand.they just slamed it together didn't check any clearances what so ever,Paid good money for junk, if you had engine work there please contact me. email me >caughtyaw@hotmail. com, With that said, and the product that I received I can only say, Don?t go there unless you have to, there are other places to spend ur money Pros: average location, by freeway ok hours, friendly staff,, Cons: Don't deliver what customer wanted and paid for, don't call back, very very dirty shop

Reasons for reporting (512 characters left):
 or  Cancel