Report a problem
Judy's Book takes violations of our Terms of Use very seriously. We encourage
you to read through our
Terms of Use
before filling report with us.
After careful review, we may remove content or replace a content warning page before
viewing content deemed offensive, harmful, or dangerous.
Additionally, we are aware that there may be content on Judy's Book that is personal
in nature or feels invasive. Please note that Judy's Book is a provider of content
creation tools, not a mediator of content. We allow our users express their opinions,
but we don't make any claims about the content of these pages. We strongly believe
in freedom of expression, even if a review contains unappealing or distasteful
content or present negative viewpoints. We realize that this may be frustrating,
and we regret any inconvenience this may cause you. In cases where contact information
for the author is listed on the page, we recommend that you work directly with this
person to have the content in question removed or changed.
Here are some examples of content we will not remove unless provided with a court
order:
Personal attacks or alleged defamation
Political or social commentary
Distasteful imagery or language
If we've read the Terms of Use and believe that this review below violates our Terms
of Use, please complete the following short form.
|
Businiess name:
Mike's Marine Custom Canvas
|
|
Review by:
citysearch c.
|
|
Review content:
Six months after putting new curtains (top of line materials selected), ran into two problems.
I removed a rear side curtain and had to really struggle to put it back.
1) No allowance for shrinkage was made. Fit was great brand new. ...My experience 8 months later... After one rear side had been off for about 4 weeks and I tried to put it back, the turn snaps missed the curtain holes by 1/2"". Took *lots* of levering and pulling to get back on. Still didn't seat the turn snaps well and they are very strained.
2) I got the welt / slide rail option. Rails extend too far aft and there is interference from the hardtop bars. I cut about an inch off the end of the rail and now the welt will slide into the rail.
Overall, was a good job, but with two annoyances. If shrinkage allowances had been made the curtains might have looked a little loose at first but would fit better in the long run. I'm concerned the turn fasteners are going to fail since they are so strained and distorted. Might need to remount them...
|
Reasons for reporting (512 characters left):
|
|
Reasons are required.
|
|
or
Cancel
|